How to Serge Around Corners

Опубликовал Admin
8-11-2020, 06:40
116
0
Serging fabric produces secure edges without no hemming necessary. However, serging around corners can be tricky. Whether you want to serge an outside corner, an inside corner, or a curved edge, there are some things you can do to make your work easier.

Serging Around an Outside Corner

  1. Serge down the first side and past the corner. Begin by serging in a straight line down the first edge of your material. Don’t stop when you reach the corner. Keep serging and go an inch or two past the end of the material and then stop the machine.
    • By going past the end, you can serge over the excess stitches and this will secure them in place.
  2. Turn the fabric and continue serging. After you stop the machine, turn the fabric so that the next edge is lined up with your serger needle. Start serging just before the corner of the material. Serge to the end of this edge and go past it as you did with the last one.
    • Continue to serge down edges and go past the edge each time. Turn the fabric each time you start on a new edge.
  3. Finish by serging over the tail. After you have serged all of your corners, go past the edge and cut the tail so that it is about an inch long. Then, lay this tail over the corner nearest to it and serge over the tail and off to the side of the material. Then, snip off the new tail.

Serging Around an Inside Corner

  1. Snip the inside corner. To prevent puckering when you are serging an inside corner, it helps to make a small cut in the fabric starting at the corner. Cut about 1/8 to 1/4 of an inch in from the corner, or the approximate width of your serged stitches.
  2. Serge down the first edge. When you are ready to start serging, start at the top of the material. Then, serge straight down the edge towards the corner. As you approach the corner, slow down. You will need to straighten the fabric and serge over the corner slowly.
  3. Straighten the corner. Just before you reach the corner, pull the edges apart to straighten out the corner. Then, continue serging over the corner and turn the fabric slightly as you transition to the new edge.
    • Another option is to serge down to the corner, stop your machine, and then pivot to continue serging over the next edge. This may be a good option for thicker fabrics that are hard to straighten out.
  4. Continue serging to the end. Serge to the bottom of the new edge and go past it by about an inch or two. This will leave a tail that you can sew back into the fabric, or sew over it as you go around an outside corner.
  5. Iron out any wrinkles in the corner after you are done. There may be a few wrinkles in the fabric after you serge over the corner. However, you can simply iron the fabric to get these wrinkles out.

Serging Around Curved Edges

  1. Lift the presser foot for an outside curve. To move the fabric in a curving fashion, you will need to release the pressure on your fabric. By lifting up the presser foot and using your fingers to guide the fabric along, you will be able to serge around the outside curve.
    • You may want to just lift the presser foot for the sharpest portion of the curve and then lower the foot back down when you get past this part.
    • Watch your fingers when you have the presser foot up! Keep them well away from the needle.
  2. Straighten out the fabric for an inside curve. If the curve is on the inside of your material, then straightening out the fabric may be your best option. Tug on both sides of the fabric to straighten it out and then serge in a straight line down the edge.
  3. Go slow. No matter what kind of curve you are serging, going slow will probably improve your results. Take your time and stop the machine if anything starts to bunch up.

Tips

Теги:
Information
Users of Guests are not allowed to comment this publication.