How to Fit a Mouth Guard

Опубликовал Admin
22-10-2016, 04:30
5 719
0
Mouth guards are an important piece of equipment in football, soccer, basketball, and many contact sports. Custom-fitting the rubber against your teeth makes the experience of wearing one much safer and more comfortable. The whole process doesn't take more than a few seconds. See Step 1 for more information.

Steps

  1. Gather the necessary materials. To properly fit your mouthguard, you'll need:
    • your mouthguard
    • scissors
    • enough boiling water to submerge the mouthguard in
    • a bowl of ice water
    • a towel
  2. Trim the mouthguard for length. You may need to trim the ends to make sure your mouthguard fits comfortably and doesn't irritate the back of your mouth. Put it in before you fit it and trim a bit off the ends if necessary. If it pokes into your mouth at the back of your jaw, or causes you to gag, trim off a little using scissors.
    • A mouthguard is mostly used to protect your vulnerable front teeth, not your molars, so you've got some wiggle-room as far as the back of the mouthguard goes. Some athletes prefer a more comfortable and short guard that covers the teeth as far as the first molars. Do what's comfortable.
  3. Submerge the mouthguard in boiling water. You need enough boiling water to submerge the mouthguard in it for between 30 and 60 seconds. Start a small pot of boiling water on the stove, or boil some in the microwave.
    • Holding the mouthguard carefully by the end strap, submerge it in the water and let it soften. If your mouthguard doesn't have a strap, or you already cut it off, you can just drop it in the water and retrieve it with a slotted spoon.
    • If you have braces, or other dental prosthetics, boil the water for only around 30 seconds. You want the mouthguard to fit your mouth, but not to fill in the crannies around your braces, which can damage them.
  4. Remove the mouthguard carefully. Quickly blot the mouthguard on the towel and get it into your mouth, adjusting it against your upper teeth. It won't be uncomfortably hot.
    • Using your thumbs, push the mouth guard up and back against your molars. Bite down firmly to get the impression of your teeth on the bottom of the mouthguard and suck the guard against your top teeth.
    • Place your tongue against the roof of the mouth to create pressure and achieve a tight fit around your teeth. This shouldn't take more than 15 or 20 seconds.
    • Don't chew the mouthguard or move it around in your mouth while you're fitting it.
  5. Place the mouthguard in the ice water. Remove the mouthguard and dunk it in the ice water. Let it cool for a minute or two and try the fit. It should fit snugly against your top teeth without having to hold it with your tongue, and it should fit naturally into your bottom teeth.
    • If you want to cut off the strap, you can do so now, or remove the removable strap.
    • If it feels uncomfortable or ill-fitting, try it again until you get a proper fit.

Tips

  • If it doesn't work the first time, then try again.
  • It doesn't matter which type of Mouth Guard you are using. These steps should work with most brands.
  • Talk to your orthodontist for instructions if you're worried about your braces.

Warnings

  • Blot the mouthguard first before putting it in your mouth to avoid burning your tongue on the water.
Теги:
Information
Users of Guests are not allowed to comment this publication.